Home lighting ceiling lighting eight installation techniques

In the home decoration, the inevitable need to install lamps. Today, the interior lighting designers to come and discuss, the installation and use of ceiling lamps attention. (1) the effect of map making designers install the ceiling in the masonry structure, the pre buried bolt, with expansion bolts, or nylon or plastic plug plug; do not use the wedge. And the bearing capacity of the fixed parts should be matched with the weight of the ceiling lamp. In order to ensure that the ceiling lamp is firm and reliable, and the service life can be prolonged. (2) when the expansion bolt is fixed, the bolt specification should be selected according to the technical requirements of the product. (3) the number of fixed socket bolt should not be less than the number of lamps on the base fixing hole, and the diameter of the bolt should match the base and aperture; no fixed hole lamp (to install punch), each lamp for bolts or screws should not be less than 2, and the center of gravity and the bolt to the lamp or screw coincide; only when the insulation pad diameter of 75mm or less, can use 1 bolts or screws. (4) and the two ends of ceiling lamps into the power line connection, electrical contact should be good, but also with black tape wrapped, and keep a certain distance, if possible, not two threads on the same piece of metal, so as to avoid the risk of short circuit. (5) the indoor effect drawing company introduces the installation of the ceiling lamp should also be checked before: 1. Lead to the cross section of the conductor wire of each lamp, the copper core flexible cord shall not be less than 0.4mm2, and the copper core shall not be less than 0.5mm2, otherwise the lead wire must be replaced. The connection between the wire and the lamp holder, the connection between the parallel wires in the lamp cap is firm, and the electrical contact should be good, so as to avoid the occurrence of sparks between the wire and the terminal due to the bad contact, and the danger is occurred. (6) educate the children not to throw balloons and other objects indoors, so as not to fall on the lights hanging decoration wounding or affect the decorative effect of lamps. If the ceiling is used in screw cap, the connection should pay attention to the following two points: the line should be connected to terminal contact center, the zero line should be connected to the terminals of the insulating casing thread; should have no damage and leakage of the lamp holder, to prevent electric shock when replacing the bulb. (7) ceiling lamp equipped with incandescent lamp, lamp bulb lamp should not close; power should also be selected according to the technical requirements of the product, can not be too large, in order to avoid the light bulb temperature is too high, the glass broken down after splashing wounding. (8) no ceiling lamps can be installed directly in the flammable objects, some families in order to beautiful three paint after lining behind the plywood ceiling lamps, in fact, this is very dangerous, we must take measures; if the temperature of surface of the light spot near combustible, also take heat or cooling measures.