Tyco new LED connector with line to board function

Recently, Tyco Electronics (Tyco) announced the launch of a new line to plate plug connector and board to board connector, further enriching the non-polar plug and socket connector series. The connector is designed to connect with the printed circuit board, which is mainly used in lighting control and LED lighting module. The new plug connector is available in support of 18-22AWG (0.3 to 0.9 mm2) strand diameter, the material is pressed with a tin plated copper terminal and has a 94V-0 flame retardant thermoplastic shell. The plug connector is used in conjunction with the board seat connector and can provide an active locking function.

Tyco Electronics Alexander Hunt III said that with the continued rapid development of LED lighting applications, manufacturers are committed to the development and installation of low-cost lighting system solutions. The introduction of the non-polar plug and socket connector to increase the line to board function, to provide customers with a complete set of connections, so that it can be quickly and flexibly connected lighting module.

Compared with the traditional polarity design, it can provide a more flexible way to install the LED printed circuit board. The new connector can be connected by two horizontal or vertical circuit board to complete the connection. The unique vertical sliding connection design, so that the replacement of the middle part of the circuit board circuit is more convenient, because only mention the circuit board to be replaced and then put in the new circuit board. The plate end connector in this series can be used either for plate to plate or for wire to plate connections.

The advantage of the non-polar design is that customers only need to store a product of the end of the board application, greatly reducing the complexity of the inventory, and because the requirements of the end plate design into the same structure, thus simplifying the design. The packaging of the terminal winding mode is convenient for the operation of the high-speed terminal equipment.

The connector can support 2, 4, 6 hole. Rated voltage is AC / DC 125V, rated current is 6 amperes. Operating temperature range of -40 DEG C to +105 C. And through the No. E28476 file UL/cUL certification.