Low pass rate of entry into force LED lighting is still the mainstream"

With the national development and Reform Commission announced on October 1, 2012 ban on the sale of 100 watts and above incandescent lamps, LED lighting industry by the support of national policy, the traditional lighting to LED lighting has been gradually transition.

In the period of replacement of incandescent lamp delisting other lighting, LED lighting is not actually consumer to resist sharp, just dare to accept. At present, the product identification on the LED market is not clear, not clear, but also the lack of uniform standards. In the face of uneven product, Guangdong Province Bureau of quality and technical supervision before the date of LED lighting products were sampling.

The spot checks in Guangzhou, Shenzhen, Zhuhai, Foshan, Zhongshan, Huizhou, Dongguan and other 7 cities in the production of 21 companies from the town of LED lamp products, a total of 23 batches, the test failed in batches of 17, the passing rate of less than 30%. It is understood that the current LED market companies and more scattered, the brand may be up to a thousand, but really worthy of trust in the brand is not much, industry experts said: 30 yuan of the following product quality is difficult to guarantee. "

LED lighting products on the market now, experts recommend to buy:

A first look at the product packaging: to see if there is no product trademarks and certification marks, such as: 3C certification, CE certification, in addition to see if clearly marked products rated voltage, voltage, temperature, precautions, safety and applicable environment etc..

Two, followed by price comparison: due to the special reasons for the production process of LED lamps, the cost is relatively high, the general domestic LED lamp prices are more than forty or fifty yuan, higher imports. In addition to see the appearance of the product is not rough, there is no glue clean, whether there is a prominent screw fixed plane? The color of the screw is consistent with the color of the shell.

Three, after lighting the lamp to carefully observe the light color change, if in a short period of time, the yellow light turned white, or white with blue by a white light, this product is to give up, because this is the case there are two possibilities: one: power problems; two: LED light source selection errors. In addition, the color of the lamp must be positive, the light color is consistent, that is, no flash. In the LED lamp after the start, through the contact surface temperature product detection products heat, if the product on the surface temperature within 1 hours continued to rise, but not the longest in 30 minutes temperature stable, do not select the product, due to heat, resulting in shortening product life.