Letter? Smart bulb failure can also be manually reset

According to Robert network reported that if you are the maintenance of intelligent lighting system, suggest you give each bulb manual reset, so the system can resume normal work of all operations is to switch a few switch, very simple.

The home of the lamp into the networking LED bulb is the easiest way to achieve smart home. Most of the time, the home of the smart lighting system to start and operate very simple, once you use the device is often used in the home automation, you basically do not need to use the phone to control the.

Sometimes the smart home system is bound to fail, then you need to re open the app for maintenance. If you're in trouble, try to restore your light bulb to the default settings. Sounds a bit complicated, in fact, it is very simple to do - to introduce to you the different brands of smart bulbs to restore the default settings:

Belkin WeMo LED bulb

First open the WeMo LED light, and then turn off, wait 1 seconds and then re open. After 3-4 seconds, repeat the operation two times. A total of three times after the close / open operation, the lamp will flash, indicating that the manual reset success.

The bulb after reset, you have only 4 minutes to put it with the WeMo Link or a compatible control device (SmartThings Hub) are matched, if not matched, then you will need to reset operation.

OSRAMLightify LED bulb

Turn on the light bulb for 5 seconds, and then turn off for 5 seconds, repeat the operation for 5 times.

TCP LED bulb

Turn off the light bulb first, then turn on the power, turn off, repeat 3 times. After the three time, turn on the light and let it shine all the time. After a few seconds, it will flash slowly, which means it can access the TCP gateway.

CREE Connected LED bulb

Cree Connected LED manual reset is the easiest we have tried to turn off the light bulb for 2 seconds, and then open for 2 seconds, and then repeat more than 3 times operation. After 4 cycles of this operation, the bulb flashes, indicating that the reset is successful.

GE Link LED bulb

GE Link LED lamp reset need to repeat 5 times off / open operation, each press a switch and so on after 3 seconds. If the operation is correct, the bulb flashes slowly, indicating that the reset is successful.

Philips Hue LED bulb

Due to the limitations of the Philips Hue API, the current can not be removed from the app a bulb, there is no simple way to manually reset the lamp operation. The best option is to restore the factory settings on the Hue Bridge button, but this operation will remove all the bulbs and the scene, then you need to reinstall the entire lighting system. The operation is as follows: switch the Bridge button, and then press the "Restore Factory Settings" button for a few seconds, to restore the factory settings.

For more information about LED, please click on China LED network or pay attention to WeChat public account (cnledw2013).